Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 333
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] notifications [in | out] command.
Parameters
Command Modes
EXEC Privilege
Usage
Information
Enter no debug ip bgp command to remove all configured debug commands for BGP.
Command
History
debug ip bgp soft-reconfiguration
c e s
Enable soft-reconfiguration debug.
Syntax
debug ip bgp {ip-address | peer-group-name} soft-reconfiguration
To disable, use the no debug ip bgp {ip-address | peer-group-name} soft-reconfiguration
command.
Parameters
Defaults
Disabled
Command Modes
EXEC Privilege
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging. If no neighbor
is specified, debug is turned on for all neighbors.
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group
peer-group-name
(OPTIONAL) Enter the keyword peer-group followed by the name of
the peer group.
in (OPTIONAL) Enter the keyword in to view BGP notifications received
from neighbors.
out
(OPTIONAL) Enter the keyword out to view BGP notifications sent to
neighbors.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name
(OPTIONAL) Enter the name of the peer group to disable or enable all
routers within the peer group.