Reference Guide

334 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Command
History
debug ip bgp updates
c e s
Enables you to view information about BGP updates.
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the
no debug ip bgp [ip-address | peer-group
peer-group-name] updates [in | out] command.
Parameters
Command Modes
EXEC Privilege
Usage
Information
Enter no debug ip bgp command to remove all configured debug commands for BGP.
Command
History
default-metric
c e s
Enables you to change the metrics of redistributed routes to locally originated routes.
Use this command with the redistribute command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced
in (OPTIONAL) Enter the keyword in to view only BGP updates received
from neighbors.
out
(OPTIONAL) Enter the keyword out to view only BGP updates sent to
neighbors.
prefix-list
prefix-list-name
(OPTIONAL) Enter the keyword prefix-list followed by the name of an
established prefix list. If the prefix list is not configured, the default is
permit (to allow all routes).
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name
(OPTIONAL) Enter the name of the peer group to disable or enable all
routers within the peer group.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1 Introduced support on C-Series