Reference Guide

338 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Usage
Information
By default, when a neighbor/peer group configuration is created in the Router BGP
context, it is enabled for the IPv4/Unicast AFI/SAFI. By using
activate in the new
context, the neighbor/peer group is enabled for AFI/SAFI.
Command
History
neighbor add-path
This command allows the specified neighbor/peer group to send/receive multiple
path advertisements.
Syntax
neighbor [ip-address | peer-group-name] add-path [send | receive | both] count
Parameters
Defaults
none
Command Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Related
Commands
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name
(OPTIONAL) Enter the name of the peer group
activate Enter the keyword activate to enable the neighbor/peer group in the
new AFI/SAFI.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
send
Enter this keyword to indicate that the system will send multiple paths
to peers.
receive
Enter this keyword to indicate that the system will accept multiple
paths from peers.
both
Enter this keyword to indicate that the system will send and accept
multiple paths from peers.
count
Enter the number paths supported.
Range: 2 to 64
bgp add-path Allow the advertisement of multiple paths for the same address prefix
without the new paths implicitly replacing any previous ones.