Reference Guide

342 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
neighbor distribute-list
c e s
Distribute BGP information via an established prefix list.
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in | out}
To delete a neighbor distribution list, use the
no neighbor {ip-address |
peer-group-name} distribute-list prefix-list-name {in | out} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
Other BGP filtering commands include neighbor filter-list, ip as-path access-list and
neighbor route-map.
Related
Commands
Command
History
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to apply the distribute list filter to all
routers in the peer group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow all
routes).
in
Enter the keyword in to distribute only inbound traffic.
out
Enter the keyword out to distribute only outbound traffic.
ip as-path access-list Configure IP AS-Path ACL.
neighbor filter-list Assign a AS-PATH list to a neighbor or peer group.
neighbor route-map Assign a route map to a neighbor or peer group.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series