Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 361
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
FTOS software resolves the network address configured by the network command
with the routes in the main routing table to ensure that the networks are reachable via
non-BGP routes and non-default routes.
Related
Commands
Command
History
network backdoor
c e s
Specify this IGP route as the preferred route.
Syntax
network ip-address mask backdoor
To remove a network, use the no network ip-address mask backdoor command.
Parameters
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for example, /
24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).
redistribute Redistribute routes into BGP.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for example, /
24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).