Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 365
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
With FTOS version 8.3.1.0 and later, the redistribute command can be used to
advertise the IGP cost as the MED
on redistributed routes. When the route-map is set
with metric-type internal and applied outbound to an EBGP peer/peer-group, the
advertised routes corresponding to those peer/peer-group will have IGP cost set as
MED.
When you enter redistribute isis
process-id command without any other parameters,
FTOS redistributes all OSPF internal routes, external type 1 routes, and external type
2 routes. This feature is not supported by an RFC.
Command
History
router bgp
c e s
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
Defaults
Not enabled.
process-id Enter the number of the OSPF process.
Range: 1 to 65535
match external {1 | 2} (OPTIONAL) Enter the keywords match external to redistribute
OSPF external routes. You can specify 1 or 2 to redistribute those
routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute
OSPF internal routes only.
route-map map-name (OPTIONAL) Enter the keywords route-map followed by the name
of a configured Route map.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced ability to substitute IGP cost for MED when a peer/
peer-group outbound route-map is set as internal.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
as-number
Enter the AS number.
Range: 1 to 65535 (2-Byte) or 1-4294967295 (4-Byte) or
0.1-65535.65535 (Dotted format)