Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 407
Defaults
Disabled.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
If the set next-hop command in the ROUTE-MAP mode is configured, its
configuration takes precedence over the neighbor next-hop-self command.
Command
History
neighbor remove-private-as
c e
t
s
Remove private AS numbers from the AS-PATH of outgoing updates.
Syntax
neighbor ip-address | peer-group-name remove-private-as
To return to the default, use the no neighbor ip-address | peer-group-name
remove-private-as command.
Parameters
Defaults
Disabled (that is, private AS number are not removed).
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
neighbor route-map
c e
t
s
Apply an established route map to either incoming or outbound routes of a BGP
neighbor or c peer group.
Syntax
neighbor [ip-address | peer-group-name] route-map map-name [in | out]
To remove the route map, use the
no neighbor [ip-address | peer-group-name] route-map
map-name [in | out] command.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
ip-address
(OPTIONAL) Enter the IP address of the neighbor to remove the private
AS numbers.
peer-group-name
(OPTIONAL) Enter the name of the peer group to remove the private
AS numbers
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series