Reference Guide

408 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one
section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
Command
History
neighbor route-reflector-client
c e
t
s
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor ip-address | peer-group-name route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector
configuration, use the
no neighbor ip-address | peer-group-name route-reflector-client
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all
routes).
in
Enter the keyword in to filter inbound routes.
out
Enter the keyword out to filter outbound routes.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.