Reference Guide

410 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Command
History
redistribute
c e
t
s
Redistribute routes into BGP.
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the
no redistribution [connected | static] [route-map
map-name] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
If you do not configure default-metric command in addition to the redistribute
command, or there is no route map to set the metric, the metric for redistributed static
and connected is “0”.
To redistribute the default route (0.0.0.0/0) configure the neighbor default-originate
command.
Related
Commands
Command
History
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
connected
Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).
neighbor default-originate Inject the default route.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series