Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 411
redistribute ospf
c e
t
s
Redistribute OSPF routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map
map-name]
To stop redistribution of OSPF routes, use the
no redistribute ospf process-id
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
When you enter redistribute ospf process-id command without any other parameters,
FTOS redistributes all OSPF internal routes, external type 1 routes, and external type
2 routes.
This feature is not supported by an RFC.
Command
History
show ip bgp ipv4 multicast
c e
t
s
View the current MBGP routing table for the system.
Syntax
show ip bgp ipv4 multicast [detail | network [network-mask] [length]]
Parameters
process-id Enter the number of the OSPF process.
Range: 1 to 65535
match external
{
1 | 2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF
external routes. You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPF
internal routes only.
route-map
map-name
(OPTIONAL) Enter the keywords
route-map followed by the name of a
configured Route map.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
detail
(OPTIONAL) Enter the keyword detail to display BGP internal
information for the IPv4 Multicast address family.
network
(OPTIONAL) Enter the network address (in dotted decimal format) of the
BGP network to view information only on that network.