Reference Guide

Bare Metal Provisioning | 433
Use the reload-type command in BMP 2.0 to toggle between Normal and Jumpstart
auto-configuration modes. The reload settings for the auto-configuration mode that
you configure are stored in memory and retained for future reboots and BMP
software upgrades. You can enter the
reload command at any time to reload the
switch in the last configured mode: Normal reload or Jumpstart mode.
Related
Commands
show reload-type
Display the currently configured reload mode.
Syntax show reload-type
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
Use the show reload-type command to check the currently configured
auto-configuration mode (Jumpstart or Normal reload) on a switch running BMP 2.0.
You can also use the
show bootvar command to display the current reload mode for
BMP 2.0 with the path of the FTOS image file retrieved from a DHCP server.
Example FTOS#show reload-type
Reload-Type : normal-reload [Next boot : normal-reload]
Related
Commands
stop jump-start
Stop the switch from reloading in Jumpstart mode to prevent an infinite loop.
Syntax stop jump-start
Defaults
None
Command Modes
EXEC Privilege
show reload-type Display the current reload mode (Normal or jump-start mode)
stop jump-start Stops the Jumpstart process to prevent a loop if the DHCP server
is not found.
Version 8.3.19.1 Introduced on S4820T.
Version 8.3.10.1 Introduced on S4810.
reload-type Configure the reload mode as normal or Jumpstart.