Reference Guide

434 | Bare Metal Provisioning
www.dell.com | support.dell.com
Command
History
Related
Commands
Usage
Information
Use the stop jump-start command on a switch running BMP 2.0 if the switch enters a
loop while reloading in Jumpstart mode; loop occurs when the switch is continuously
trying to contact a DHCP server and a DHCP server is not found. The
stop jump-start
command stops the switch from connecting to the DHCP server. After the
stop
jump-start
command is used, the next default reload type will be a normal reload. This
will be indicated in the show reload-type command.
Version 8.3.19.0 Introduced on S4820T.
Version 8.3.10.1 Introduced on S4810.
reload-type Configure the reload mode as normal or Jumpstart.