Reference Guide

438 | Content Addressable Memory (CAM)
www.dell.com | support.dell.com
cam-acl-egress (Configuration)
c s
Select the FP groups for CAM access control lists for Layer 2, IPv4 and IPv6 ACLs.
Syntax
cam-acl-egress {default | l2acl number ipv4acl number ipv6acl number}
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run
start
) then reload the system for the new settings to take effect.
There are 4 groups total. You must allocate at least one group for L2ACL and IPv4
ACL.
Ranges for the CAM profiles are 1 to 4 for
l2acl. The range for the ipv6acl profile is 0
to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-acl (EXEC Privilege)
c s
Adjust linecard CAM setting to match chassis settings.
This command is deprecated as of FTOS 8.3.1.0
Syntax
cam-acl {chassis |linecard}
Command Modes
EXEC Privilege
Command
History
default
Reset the egress CAM ACL entries to the default settings.
l2acl number ipv4acl number
ipv6acl number
Allocate space to each CAM region.
Enter the CAM profile name followed by the amount of
CAM space to be allotted.
The total space allocated must equal 13.
l2acl range: 1 to 4
ipv4acl range: 1 to 4
ipv6acl range: 0 to 4
Version 8.3.19.0 Introduced on the S4820T
Version 8.3.10.0 Introduced on the S4810
Version 8.3.1.0 Added
ecfmacl, vman-qos, and vman-dual-qos keywords.
Version 8.2.1.0 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series
Version 8.3.1.0 COMMAND DEPRECATED
Version 7.8.1.0 Introduced on the C-Series