Reference Guide

Content Addressable Memory (CAM) | 441
Usage
Information
You must save the running configuration using the command copy running-config
startup-config after changing the CAM profile from CONFIGURATION mode. CAM
profile changes take effect after the next chassis reboot.
show cam-acl
c s
Display the details of the CAM profiles on the chassis and all line cards.
Syntax show cam-acl
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
The display reflects the settings implemented with the cam-acl command.
Example
(default for
C-Series /
S-Series)
FTOS#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 6
Ipv4Acl : 5
Ipv6Acl : 0
Ipv4Qos : 1
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
VmanDualQos: 0
Version 7.9.1.0 Added support for VRF protocols.
Version 7.5.1.0 Added the l2-ipv4-inacl CAM profile
Version 7.4.2.0 Added the unified-default CAM profile and lag-hash-align microcode
Version 7.4.1.0 Added the lag-hash-mpls microcode
Version 6.5.1.0 Added the eg-default and ipv4-320k CAM profiles
Version 6.3.1.0 Introduced on E-Series
Note: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs.
Note: Do not make any changes to the CAM profile after you change the profile to
ipv4-320K and save the configuration until after you reload the chassis; any changes
lead to unexpected behavior. After you reload the chassis, you may make changes to
the IPv4 Flow partition.
Version 8.3.19.0 Introduced on S4820T.
Version 8.3.12.0 Introduced on S4810.
Version 7.8.1.0 Introduced on C-Series