Reference Guide

470 | Data Center Bridging
www.dell.com | support.dell.com
dcb-output
Create a DCB output policy to associate an ETS configuration with priority traffic.
Syntax
dcb-output policy-name
To remove the ETS output policy globally, use the no dcb output policy-name command.
Parameters
Defaults
none
Command Modes
CONFIGURATION
Command
History
Usage
Information
Create a DCB output policy to associate a priority group with an ETS output policy with scheduling
and bandwidth configuration. You can apply a DCB output policy on multiple egress ports. When you
apply an ETS output policy on an interface, ETS-configured scheduling and bandwidth allocation take
precedence over any configured settings in QoS output policies.
The ETS configuration associated with 802.1 priority traffic in a DCB output policy is used in DCBX
negotiation with ETS peers.
Related
Commands
dcb-policy input
Apply the input policy with the PFC configuration to an ingress interface.
Syntax
dcb-policy input policy-name
To delete the input policy, use the no dcb-policy input command.
Parameters
Defaults
none
Command Modes
INTERFACE
policy-name
Enter the DCB output policy name.
Maximum: 32 alphanumeric characters.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
dcb-policy output Apply the output policy.
policy name
Enter the input policy name with the PFC configuration to an ingress interface.