Reference Guide

472 | Data Center Bridging
www.dell.com | support.dell.com
Command
History
Usage
Information
The dcb-policy input stack-unit all command overwrites any previous dcb-policy input stack-unit
stack-unit-id
configurations. Similarly, a dcb-policy input stack-unit stack-unit-id command
overwrites any previous
dcb-policy input stack-unit all configuration.
Related
Commands
dcb-policy output
Apply the output policy with the ETS configuration to an egress interface.
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
Defaults
none
Command Modes
INTERFACE
Command
History
Usage
Information
When you apply an ETS output policy to on interface, ETS-configured scheduling and bandwidth
allocation take precedence over any configured settings in QoS output policies.
When DCB is disabled, ETS is disabled by default. When DCB is enabled, ETS is enabled for all
interfaces that has the default ETS configuration applied (all dot1p priorities in the same group with
equal bandwidth allocation).
Related
Commands
dcb-policy output stack-unit stack-ports all
Apply the specified DCB output policy on all ports of the switch stack or a single stacked switch.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
dcb-policy output stack-unit
stack-ports all
Apply the specified DCB output policy.
policy name
Enter the output policy name.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
dcb-output Create a DCB output policy.