Reference Guide

478 | Data Center Bridging
www.dell.com | support.dell.com
Command
History
Usage
Information
If you disable ETS in an output policy applied to an interface using the no ets mode on command, any
previously configured QoS settings at the interface or global level take effect. If QoS settings are
configured at the interface or global level and in an output policy map (
service-policy output
command), the QoS configuration in the output policy takes precedence.
Related
Commands
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
Defaults
0x8
Command Modes
PROTOCOL LLDP
Command
History
Usage
Information
This command is available at the global level only.
iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits command.
Version 8.3.19.0 Introduced on the S4820T
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
dcb-output Create a DCB output policy.
dcb-policy output Apply the output policy.
priority-bitmap
Enter the priority-bitmap range.
Range: 1 to FF.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module