Reference Guide

492 | Data Center Bridging
www.dell.com | support.dell.com
Table 13-3 lists the show interface ets detail field descriptions.
Usage
Information
To clear ETS TLV counters, use the clear ets counters interface port-type slot/port command.
show interface pfc
Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link
delay.
Syntax
show interface port-type slot/port pfc {summary | detail}
Table 13-3. show interfaces ets detail Command Example Fields
Field Description
Interface Interface type with stack-unit and port number.
Max Supported TC Group Maximum number of priority groups supported.
Number of Traffic Classes Number of 802.1p priorities currently configured.
Admin mode ETS mode: on or off.
When on, the scheduling and bandwidth allocation configured in an ETS output
policy or received in a DCBX TLV from a peer can take effect on an interface.
Admin Parameters ETS configuration on local port, including priority groups, assigned dot1p
priorities, and bandwidth allocation.
Remote Parameters ETS configuration on remote peer port, including admin mode (enabled if a valid
TLV was received or disabled), priority groups, assigned dot1p priorities, and
bandwidth allocation. If ETS admin mode is enabled on the remote port for DCBX
exchange, the Willing bit received in ETS TLVs from the remote peer is included.
Local Parameters ETS configuration on local port, including admin mode (enabled when a valid TLV
is received from a peer), priority groups, assigned dot1p priorities, and bandwidth
allocation.
Operational status (local
port)
Port state for current operational ETS configuration:
•
Init: Local ETS configuration parameters were exchanged with the peer.
• Recommend: Remote ETS configuration parameters were received from the
peer.
• Internally propagated: ETS configuration parameters were received from
the configuration source.
ETS DCBX Oper status Operational status of the ETS configuration on the local port: match or mismatch.
State Machine Type Type of state machine used for DCBX exchanges of ETS parameters:
Feature - for legacy DCBX versions; Asymmetric - for an IEEE version.
Conf TLV Tx Status Status of ETS Configuration TLV advertisements: enabled or disabled.
ETS TLV Statistic: Input
Conf TLV pkts
Number of ETS Configuration TLVs received.
ETS TLV Statistic:
Output Conf TLV pkts
Number of ETS Configuration TLVs transmitted.
ETS TLV Statistic: Error
Conf TLV pkts
Number of ETS Error Configuration TLVs received.