Reference Guide

Force10 Resilient Ring Protocol (FRRP) | 547
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-frrp)
Command
History
Usage
Information
This command causes the Ring Manager to take ownership of these two ports after
the configuration is validated by the IFM. Ownership is relinquished for a port only
when the interface does not play a part in any control VLAN, that is, the interface
does not belong to any ring.
Related
Commands
member-vlan
c e
Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the
no member-vlan [vlan-range] command.
Parameters
secondary interface
Enter the keyword secondary to configure the secondary interface
followed by one of the following interfaces and slot/port information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale
and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
control-vlan vlan-id
Enter the keyword control-vlan followed by the VLAN ID.
Range: 1 to 4094
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
show frrp Display the Resilient Ring Protocol configuration information
vlan-range
Enter the member VLANs using comma separated VLAN IDs, a range of
VLAN IDs, a single VLAN ID, or a combination. For example:
Comma separated: 3, 4, 6
Range: 5-10
Combination: 3, 4, 5-10, 8