Reference Guide

556 | GARP VLAN Registration (GVRP)
www.dell.com | support.dell.com
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
disable
c e s
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults
Enabled
Command Modes
CONFIGURATION-GVRP
Command
History
Related
Commands
pdu
Enter the keyword pdu followed one of the following Interface keywords and
slot/port or number information:
(Not available on S4810 or S4820T)
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1
to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed
by the slot/port information.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on C, E, and S-Series
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on C, E, and S-Series
gvrp enable Enable GVRP on physical interfaces and LAGs.
protocol gvrp Access GVRP protocol