Reference Guide

582 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
ip igmp access-group
c e s
Use this feature to specify access control for packets.
Syntax ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list command.
Parameters
Defaults
Not configured
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
Usage
Information
The access list accepted is an extended ACL. This feature is used to block IGMP
reports from hosts, on a per-interface basis; based on the group address and source
address specified in the access list.
ip igmp group-join-limit
c e s
Use this feature to limit the number of IGMP groups that can be joined in a second.
Syntax ip igmp group-join-limit number
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-if-interface-slot/port)
Command
History
access-list
Enter the name of the extended ACL (16 characters maximum).
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced on E-Series
number
Enter the number of IGMP groups permitted to join in a second.
Range: 1 to 10000
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced on E-Series