Reference Guide

584 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
Command Modes
INTERFACE
Command
History
ip igmp querier-timeout
c e s
Change the interval that must pass before a multicast router decides that there is no
longer another multicast router that should be the querier.
Syntax
ip igmp querier-timeout
seconds
To return to the default value, enter
no ip igmp querier-timeout.
Parameters
Defaults
125 seconds
Command Modes
INTERFACE
Command
History
ip igmp query-interval
c e s
Change the transmission frequency of IGMP general queries sent by the Querier.
Syntax
ip igmp query-interval
seconds
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
E-Series legacy command
seconds Enter the number of seconds the router must wait to become the new querier.
Default: 125 seconds
Range: 60 to 300
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on S-Series in Interface VLAN mode only to enable that system to
act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on C-Series in Interface VLAN mode only to enable that system to
act as an IGMP Proxy Querier.
E-Series legacy command