Reference Guide

586 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
ip igmp ssm-map
c e s
Use a statically configured list to translate (*,G) memberships to (S,G) memberships.
Syntax
ip igmp ssm-map
std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with
(*,G) states using the command
ip igmp ssm-map std-access-list source-address
command.
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected
in the IGMP groups. You may not use extended access lists with this command.
When a static SSM map is configured and the router cannot find any matching access
lists, the router continues to accept (*,G) groups.
Related
Commands
ip igmp static-group
c e s
Configure an IGMP static group.
Version 7.6.1.0 Introduced on S-Series in Interface VLAN mode only to enable that system to
act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on C-Series in Interface VLAN mode only to enable that system to
act as an IGMP Proxy Querier.
E-Series legacy command
std-access-list
Specify the standard IP access list that contains the mapping rules for
multicast groups.
source-address
Specify the multicast source address to which the groups are mapped.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.7.1.0 Introduced on E-Series
ip access-list standard Create a standard access list to filter based on IP address.