Reference Guide

Internet Group Management Protocol (IGMP) | 591
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
IGMP commands accept only non-VLAN interfaces — specifying VLAN will not
yield a results.
Example
FTOS#show ip igmp interface
GigabitEthernet 0/0 is down, line protocol is down
Internet protocol processing disabled
GigabitEthernet 0/5 is down, line protocol is down
Internet protocol processing disabled
GigabitEthernet 0/6 is down, line protocol is down
Internet protocol processing disabled
GigabitEthernet 0/7 is up, line protocol is down
Internet protocol processing disabled
GigabitEthernet 7/9 is up, line protocol is up
Internet address is 10.87.5.250/24
IGMP is enabled on interface
IGMP query interval is 60 seconds
IGMP querier timeout is 120 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP activity: 0 joins, 0 leaves
IGMP querying router is 10.87.5.250 (this system)
IGMP version is 2
FTOS#
interface (OPTIONAL) Enter the interface type and slot/port information:
• For a 100/1000 Ethernet interface, enter the keyword
gigabitethernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a Loopback interface, enter the keyword
loopback followed by a number
from 0 to 16383.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN interface enter the keyword vlan followed by a number from 1 to
4094.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command