Reference Guide

Interfaces | 607
Command
History
Usage
Information
This command applies only to the Management interface on the RPMs.
Related
Commands
duplex (10/100 Interfaces)
c e s
Configure duplex mode on any physical interfaces where the speed is set to 10/100.Syntax
duplex {half | full}
To return to the default setting, enter
no duplex.
Parameters
Defaults
Not configured
Command Modes
INTERFACE
Command
History
Usage
Information
This command applies to any physical interface with speed set to 10/100.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
Version 6.4.1.0 Documentation modified—added Management to distinguish from duplex (10/
100 Interfaces)
interface ManagementEthernet Configure the Management port on the system (either the
Primary or Standby RPM).
duplex (Management) Set the mode of the Management interface.
management route Configure a static route that points to the Management
interface or a forwarding router.
speed (Management interface) Set the speed on the Management interface.
half
Enter the keyword half to set the physical interface to transmit only in one direction.
full
Enter the keyword full to set the physical interface to transmit in both directions.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.4.1.0 Introduced
Note: Starting with FTOS 7.8.1.0, when a copper SFP2 module with catalog number
GP-SFP2-1T is used in the S25P model of the S-Series, its speed can be manually set
with the
speed command. When the speed is set to 10 or 100 Mbps, the duplex
command can also be executed.