Reference Guide

608 | Interfaces
www.dell.com | support.dell.com
Related
Commands
ecmp-group
Provides a mechanism to monitor traffic distribution on a LAG link bundle. A system log or
SNMP trap is generated when the standard deviation of traffic distribution on a member link
exceeds a defined threshold.
Syntax
ecmp-group {ecmp-path} [interface interface] [monitoring enable]
To negate a command, use the
no command.
Parameters
Defaults
Off
Command Modes
CONFIGURATION
Command
History
flowcontrol
c e s
Control how the system responds to and generates 802.3x pause frames on 1Gig and 10Gig
line cards.
Syntax
flowcontrol rx {off | on} tx {off | on} threshold {<1-2047> <1-2013> <1-2013>}
The
threshold keyword is supported on C-Series and S-Series only.
speed (for 10/100/1000 interfaces) Set the speed on the Base-T Ethernet interface.
negotiation auto Enable or disable auto-negotiation on an interface.
ecmp-path
Enter the path number for the LAG.
Range: 2 to 64
interface
Enter the following keywords and slot/port to add the interface to the
LAG.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
monitoring
Enter the keyword monitoring to monitor the LAG. To enable
monitoring, follow by entering the keyword
enable.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.10.0 Introduced on S4810