Reference Guide

Interfaces | 613
FTOS(conf-if-lo-1655)#
Related
Commands
interface ManagementEthernet
c e s
Z
Configure the Management port on the system (either the Primary or Standby RPM).
Syntax
interface ManagementEthernet slot/port
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). Use the ip address command to
assign an IP address to the Management port.
If two RPMs are installed in your system, use the show redundancy command to display
which RPM is the Primary RPM.
Related
Commands
interface Configure a physical interface.
interface null Configure a Null interface.
interface port-channel Configure a port channel.
interface vlan Configure a VLAN.
slot/port
Enter the keyword ManagementEthernet followed by slot number (0-1) and
port number zero (0).
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.11.1 Introduced on S55, S60 and S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced for C-Series
Version 6.4.1.0 Introduced for E-Series
management route Configure a static route that points to the Management interface
or a forwarding router.
duplex (Management) Clear FIB entries on a specified line card.
speed (Management interface) Clear FIB entries on a specified line card.