Reference Guide

616 | Interfaces
www.dell.com | support.dell.com
• If overlapping port ranges are specified, the port range is extended to the smallest
start port and the biggest end port.
Example
(Bulk Configuration
Warning message)
FTOS(conf)#interface range so 2/0 - 1 , te 10/0 , gi 3/0 , fa 0/0
% Warning: Non-existing ports (not configured) are ignored by interface-range
Example
(Interface Range
prompt with
multiple ports)
FTOS(conf)#interface range gi 2/0 - 23 , gi 2/1 - 10
FTOS(conf-if-range-gi-2/0-23#
Example
(Interface Range
prompt with
overlapping port
ranges)
FTOS(conf)#interface range gi 2/1 - 11 , gi 2/1 - 23
FTOS(conf-if-range-gi-2/1-23#
Only VLAN and port-channel interfaces created using the interface vlan and interface
port-channel commands can be used in the
interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces.
VLAN or port-channel interfaces that are not displayed in the show running-config command
can not be used with the bulk configuration feature of the
interface range command. You
cannot create virtual interfaces (VLAN, Port-channel) using the
interface range command.
Example
(Single Range Bulk
Configuration)
The following text is an example of a single range bulk configuration.
FTOS(config)# interface range gigabitethernet 5/1 - 23
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#
Example
(Multiple Range Bulk
Configuration Gigabit
Ethernet & Ten Gigabit
Ethernet)
The following example shows how to use commas to add different interface types to the range
enabling all Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet
interfaces 1/1 and 1/2.
FTOS(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet
1/1 - 2
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#
Example
(Multiple Range Bulk
Configuration with
SONET, VLAN, and
port channel)
The following figure shows how to use commas to add SONET, VLAN, and port-channel
interfaces to the range.
FTOS(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet
1/1 – 2, Vlan 2 – 100 , Port 1 – 25
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#
Related
Commands
Note: If a range has VLAN, physical, port-channel, and SONET interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN, port-channel or SONET, only those respective
interfaces should be configured in a particular range.
interface port-channel Configure a port channel group.
interface vlan Configure a VLAN interface.