Reference Guide

Interfaces | 617
interface range macro (define)
c e s
Defines a macro for an interface range and then saves the macro in the running configuration.
Syntax
define interface range macro name interface , interface , ...
Parameters
Defaults
This command has no default behavior or value.
Command Modes
CONFIGURATION
Command
History
show config (from INTERFACE
RANGE mode)
Show the bulk configuration interfaces.
show range Show the bulk configuration ranges.
interface range macro (define) Define a macro for an interface-range.
name
Enter up to 16 characters for the macro name.
interface , interface ,...
Enter the interface keyword ( below) and one of the interfaces slot/
port, port-channel or VLAN numbers. Select the range of interfaces
for bulk configuration. You can enter up to six comma separated
ranges—spaces are not required between the commas.
Comma-separated ranges can include VLANs, port-channels and
physical interfaces.
Slot/Port information must contain a space before and after the dash.
For example,
interface range gigabitethernet 0/1 - 5 is valid;
interface range gigabitethernet 0/1-5 is not valid.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale
and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from
1 to 4094.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced