Reference Guide

618 | Interfaces
www.dell.com | support.dell.com
Example
FTOS(config)# define interface-range test tengigabitethernet 0/0 - 3 ,
gigabitethernet 5/0 - 47 , gigabitethernet 13/0 - 89
FTOS# show running-config | grep define
define interface-range test tengigabitethernet 0/0 - 3 , gigabitethernet 5/0 -
47 , gigabitethernet 13/0 - 89
FTOS(config)#interface range macro test
FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
Usage
Information
The above text is an example of how to define an interface range macro named test. Execute
the
show running-config command to display the macro definition.
Related
Commands
interface range macro name
c e s
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax
interface range macro name
Parameters
Defaults
This command has no default behavior or value
Command Modes
CONFIGURATION
Command
History
Usage
Information
The following figure runs the macro named test that was defined earlier.
Example
FTOS(config)#interface range macro test
FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
FTOS
Related
Commands
interface vlan
c e s
Configure a VLAN. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
interface range Configure a range of command (bulk configuration)
interface range macro name Run an interface range macro.
name
Enter the name of an existing macro.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced
interface range Configure a range of command (bulk configuration)
interface range macro (define) Define a macro for an interface range (bulk configuration)