Reference Guide

Interfaces | 619
Parameters
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes
CONFIGURATION
Command
History
Example
FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#
Usage
Information
For more information on VLANs and the commands to configure them, refer to Virtual LAN
(VLAN) Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not
supported in VLANs. IP ACLs are supported. Refer to the Access Control Lists (ACL)
chapter.
Related
Commands
ipg (Gigabit Ethernet interfaces)
e
Set the Inter-packet gap (IPG) to 8 bytes for traffic on a Gigabit Ethernet interface.
Syntax
ipg 8
To return to the default setting, enter
no ipg.
Parameters
Defaults
12 bytes
vlan-id
Enter a number as the VLAN Identifier.
Range: 1 to 4094.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported
2094.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version
6.2.1.0
Introduced for E-Series
interface Configure a physical interface.
interface loopback Configure a loopback interface.
interface null Configure a null interface.
interface port-channel Configure a port channel group.
show vlan Display the current VLAN configuration on the switch.
shutdown Disable/Enable the VLAN.
tagged Add a Layer 2 interface to a VLAN as a tagged interface.
untagged Add a Layer 2 interface to a VLAN as an untagged interface.
8
Enter the keyword 8 to set the IPG to 8 bytes.