Reference Guide

624 | Interfaces
www.dell.com | support.dell.com
Gi 0/19 Down 0 0 0
0
Gi 0/20 Up 62734 54 62766
18
Gi 0/21 Up 60198 9 200899
9
Gi 0/22 Up 17304741100 3157554 10102508511
1114221
Gi 0/23 Up 17304769659 3139507 7133354895
523329
m - Change mode c - Clear screen
b - Display bytes r - Display pkts/bytes per sec
l - Page up a - Page down
T - Increase refresh interval t - Decrease refresh interval
q - Quit
mtu
c e s
Z
Set the maximum Link MTU (frame size) for an Ethernet interface.
Syntax
mtu value
To return to the default MTU value, enter
no mtu.
Table 23-2. monitor Command Menu Options
Key Description
systest-3 Displays the host name assigned to the system.
monitor time Displays the amount of time since the monitor interface command was entered.
time Displays the amount of time the chassis is up (since last reboot).
m Change the view from a single interface to all interfaces on the line card or
visa-versa.
c Refresh the view.
b Change the counters displayed from Packets on the interface to Bytes.
r Change the [delta] column from change in the number of packets/bytes in the last
interval to rate per second.
l Change the view to next interface on the line card, or if in the line card mode, the
next line card in the chassis.
a Change the view to the previous interface on the line card, or if the line card mode,
the previous line card in the chassis.
T Increase the screen refresh rate.
t Decrease the screen refresh rate.
q Return to the CLI prompt.