Reference Guide

630 | Interfaces
www.dell.com | support.dell.com
Parameters
Defaults
299 seconds
Command Modes
INTERFACE
Command
History
Usage
Information
The configured rate interval is displayed, along with the collected traffic data, in the output of
show interfaces commands.
Related
Commands
show config
c e s
Display the interface configuration.
Syntax
show config
Command Modes
INTERFACE
Command
History
Example
FTOS(conf-if)#show conf
!
interface GigabitEthernet 1/7
no ip address
switchport
no shutdown
FTOS(conf-if)#
seconds Enter the number of seconds for which to collect traffic data.
Range: 30 to 299 seconds
Note: Since polling occurs every 15 seconds, the number of seconds designated
here will round to the multiple of 15 seconds lower than the entered value. For
example, if 44 seconds is designated it will round to 30; 45 to 59 seconds will
round to 45, and so forth.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced
show interfaces Display information on physical and virtual interfaces.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series