Reference Guide

64 | File Management
www.dell.com | support.dell.com
Related
Commands
0
Usage
Information
On E-Series ExaScale, you cannot upgrade SFMs using this command when Cache
Boot is configured. If you attempt an upgrade, you must reload the chassis to recover.
Upgrading the C-Series FPGA
These commands are for upgrading the FPGA for C-Series RPMs and line cards.
• restore fpga-imagee
• upgrade fpga-image
restore fpga-image
c
Copy the backup C-Series FPGA image to the primary FPGA image.
Syntax
restore fpga-image {rpm | linecard} number
Parameters
Defaults
None.
Command Mode
EXEC Privilege
Command
History
Example
FTOS#restore fpga-image linecard 4
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
------------------------------------------------------------------------
LC4 48 Port 1G LCM FPGA A: 3.6 restore
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Restore fpga image for linecard 4 [yes/no]: yes
show sfm Display the SFM status.
upgrade (E-Series version) Upgrade the E-Series.
rpm
Enter rpm to upgrade an RPM FPGA.
linecard
Enter linecard to upgrade a line card FPGA.
number
Enter the line card or RPM slot number.
C-Series Line Card Range: 0-7, RPM Range: 0-1
Version 7.7.1.0 Renamed keyword primary-fpga-flash to fpga-image.
Version 7.5.1.0 Introduced on C-Series