Reference Guide

Interfaces | 643
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS#show int gigabitethernet 1/0 phy
Mode Control:
SpeedSelection: 10b
AutoNeg: ON
Loopback: False
PowerDown: False
Isolate: False
DuplexMode: Full
Mode Status:
AutoNegComplete: False
RemoteFault: False
LinkStatus: False
JabberDetect: False
AutoNegotation Advertise:
100MegFullDplx: True
100MegHalfDplx: True
10MegFullDplx: False
10MegHalfDplx: True
Asym Pause: False
Sym Pause: False
AutoNegotiation Remote Partner's Ability:
100MegFullDplx: False
100MegHalfDplx: False
10MegFullDplx: False
10MegHalfDplx: False
Asym Pause: False
Sym Pause: False
AutoNegotiation Expansion:
ParallelDetectionFault: False
...
gigabitethernet
Enter the keyword gigabitethernet followed by the slot/port
information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on C-Series and S-Series
Version 6.5.4.0 Introduced on E-Series
Table 23-7. Lines in show interfaces gigabitethernet Command Example
Line Description
Mode Control Indicates if auto negotiation is enabled. If so, indicates the selected
speed and duplex.
Mode Status Displays auto negotiation fault information. When the interface
completes auto negotiation successfully, the autoNegComplete field
and the linkstatus field read “True.”
AutoNegotiation Advertise Displays the control words advertised by the local interface during
negotiation. Duplex is either half or full. Asym- and Sym Pause is the
types of flow control supported by the local interface.