Reference Guide

644 | Interfaces
www.dell.com | support.dell.com
Related
Commands
show interfaces stack-unit
s z
Display information on all interfaces on a specific S-Series stack member.
Syntax
show interfaces stack-unit unit-number
Parameters
Command Modes
EXEC
AutoNegotiation Remote
Partner’s Ability
Displays the control words advertised by the remote interface during
negotiation. Duplex is either half or full. Asym- and Sym Pause is the
types of flow control supported by the remote interface
AutoNegotiation
Expansion
ParallelDetectionFault is the handshaking scheme in which the link
partner continuously transmit an “idle” data packet using the Fast
Ethernet MLT-3 waveform. Equipment that does not support
auto-negotiation must be configured to exactly match the mode of
operation as the link partner or else no link can be established.
1000Base-T Control 1000Base-T requires auto-negotiation. The IEEE Ethernet standard
does not support setting a speed to 1000 Mbps with the speed
command without auto-negotiation. E-Series line cards support both
full-duplex and half-duplex 1000BaseT.
Phy Specific Control Values are:
0 - Manual MDI
1 - Manual MDIX
2 - N/A
3 - Auto MDI/MDIX
Phy Specific Status Displays PHY-specific status information. Cable length represents a
rough estimate in meters:
0 - < 50 meters
1 - 50 - 80 meters
2 - 80 - 110 meters
3 - 110 - 140 meters
4 - 140 meters.
Link Status:
Up or Down
Speed:
Auto
1000MB
100MB
10MB
Table 23-7. Lines in show interfaces gigabitethernet Command Example
Line Description
show interfaces Display information on a specific physical interface or virtual
interface.
unit-number
Enter the stack member number (0 to 7).