Reference Guide

Interfaces | 653
Related
Commands
show range
c e s
Display all interfaces configured using the interface range command.
Syntax
show range
Command Mode
INTERFACE RANGE (config-if-range)
Command
History
Example
FTOS(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
FTOS(conf-if-range-so-2/0-1,fa-0/0)#
Related
Commands
show running-config ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution
using the ecmp-group monitoring enable command. The ECMP group could have a LAG or a
list of 10G/40 interfaces (not just LAG link-bundles).
Tx Power Low Warning
Flag
This can be either true or false, depending on the Current Tx power
value displayed above.
Rx Power Low Warning
Flag
This can be either true or false, depending on the Current Rx power
value displayed above.
Table 23-9. Diagnostic Data in show interfaces transceiver (continued)
Line Description
interface Configure a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Display information on a specific physical interface or virtual interface.
show inventory
(C-Series and E-Series)
Display the chassis type, components (including media), FTOS version
including hardware identification numbers and configured protocols.
show inventory
(S-Series)
Display the S-Series switch type, components (including media), FTOS
version including hardware identification numbers and configured
protocols.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced
interface Configure a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Display information on a specific physical interface or virtual interface.