Reference Guide

654 | Interfaces
www.dell.com | support.dell.com
Syntax
show running-config ecmp-group
Command Mode
CONFIGURATION
Defaults
Disabled
Command
History
Related
Commands
shutdown
c e s
Disable an interface.
Syntax
shutdown
To activate an interface, enter no shutdown.
Defaults
The interface is disabled.
Command Modes
INTERFACE
Command
History
Usage
Information
The shutdown command marks a physical interface as unavailable for traffic. To discover if
an interface is disabled, use the
show ip interface brief command. Disabled interfaces are
listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is disabled, the
Layer 3 functions within that VLAN are disabled. Layer 2 traffic continues to flow. Entering
the
shutdown c command on a port channel disables all traffic on the port channel and the
individual interfaces within the port channel. To enable a port channel, you must enter no
shutdown on the port channel interface and at least one interface within that port channel.
The
shutdown c and description commands are the only commands that you can configure on
an interface that is a member of a port channel.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.10.0 Introduced on S4810
ecmp-group Configure a mechanism to monitor traffic distribution.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command