Reference Guide

660 | Interfaces
www.dell.com | support.dell.com
Table 23-10. Port Channel Limits
Because each port can be assigned to only one Port Channel, and each Port Channel must
have at least one port, some of those nominally available Port Channels might have no
function because they could have no members if there are not enough ports installed. In the
S-Series, those ports could be provided by stack members.
The commands in this section are specific to Port Channel interfaces:
• channel-member
• group
• interface port-channel
• minimum-links
• port-channel failover-group
• show config
• show interfaces port-channel
• show port-channel-flow
channel-member
c e s
Add an interface to the Port Channel, while in the INTERFACE PORTCHANNEL mode.
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Platform
Maximum Port
Channel IDs
Maximum Members per
Port Channel
E-Series ExaScale 255 64
E-Series TeraScale 255 16
E-Series EtherScale 32 16
C-Series 128 8
S-Series 128 8
Note: The FTOS implementation of LAG or Port Channel requires that you configure
a LAG on both switches manually. For information on FTOS Link Aggregation Control
Protocol (LACP) for dynamic LAGs, refer to Link Aggregation Control Protocol
(LACP).
For more information on configuring and using Port Channels, refer to the FTOS
Configuration Guide.