Reference Guide

Control and Monitoring | 67

Control and Monitoring

Overview

This chapter contains the following commands to configure and monitor the system,

including Telnet, FTP, and TFTP as they apply to the following Dell Force10

platforms

e E-Series, c C-Series, s S-Series, , or .

Commands

Note: Beginning in release 8.3.10.0, the enable xfp-power-updates command was

deprecated for the S4810 only. It was replaced by the

enable optic-info-update interval

command to update information on temperature and power monitoring in the SNMP

MIB.

asf-mode rpm <slot> location-led

audible cut-off send

banner exec service timestamps

banner login show alarms

banner motd show chassis

cam-audit linecard show command-history

cam-audit stack-unit show command-tree

clear alarms show console lp

clear command history show cpu-traffic-stats

clear line show debugging

configure show environment (C-Series and E-Series)

debug cpu-traffic-stats show environment (S-Series)

debug ftpserver show inventory (C-Series and E-Series)

disable show inventory (S-Series)

do show linecard

enable show linecard boot-information

enable optic-info-update interval show memory (C-Series and E-Series)

enable xfp-power-updates show memory (S-Series)