Reference Guide

674 | Interfaces
www.dell.com | support.dell.com
Related
Commands
Command
History
ip udp-broadcast-address
e
Configure an IP UDP address for broadcast.
Syntax
ip udp-broadcast-address address
To delete the configuration, use the
no ip udp-broadcast-address address command.
Parameters
Defaults
Not Configured
Command Modes
INTERFACE (config-if)
Usage
Information
When a UDP broadcast packet is flooded out of an interface, and the outgoing interface is
configured using this command, the outgoing packet’s IP destination address is replaced with
the configured broadcast address.
Command
History
Related
Commands
ip udp-helper udp-port
e
Enable the UDP broadcast feature on an interface either for all UDP ports or a specified list of
UDP ports.
Syntax
ip udp-helper udp-port [udp-port-list]
To disable the UDP broadcast on a port, use the
no ip udp-helper udp-port [udp-port-list]
command.
ip udp-broadcast-address Configure a UDP IP address for broadcast
ip udp-helper udp-port Enable the UDP broadcast feature on an interface.
show ip udp-helper Display the configured UDP helper(s) on all interfaces.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Pre-version 8.3.7.0 Introduced on E-Series ExaScale
address
Enter an IP broadcast address in dotted decimal format (A.B.C.D).
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Pre-version 8.3.7.0 Introduced on E-Series ExaScale
debug ip udp-helper Enable debug and display the debug information on a console.
show ip udp-helper Display the configured UDP helper(s) on all interfaces.