Reference Guide

70 | Control and Monitoring
www.dell.com | support.dell.com
Command
History
Usage
Information
Optionally, use the banner exec command to create a text string that is displayed
when the user accesses the EXEC mode. The
exec-banner command toggles that
display.
Example
FTOS(conf)#banner exec ?
LINE c banner-text c, where 'c' is a delimiting character
FTOS(conf)#banner exec %
Enter TEXT message. End with the character '%'.
This is the banner%
FTOS(conf)#end
FTOS#exit
4d21h5m: %RPM0-P:CP %SEC-5-LOGOUT: Exec session is terminated for user on line console
This is the banner
FTOS con0 now available
Press RETURN to get started.
4d21h6m: %RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user on line console
This is the banner
FTOS>
Related
Commands
banner login
c e s
Set a banner to be displayed when logging on to the system.
Syntax
banner login {keyboard-interactive | no keyboard-interactive} [c line c]
Parameters
Defaults
No banner is configured and the CR is required when creating a banner.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
banner login Sets a banner for login connections to the system.
banner motd Sets a Message of the Day banner.
exec-banner Enable the display of a text string when the user enters the EXEC mode.
line Enable and configure console and virtual terminal lines to the system.
keyboard-interactive Enter this keyword to require a carriage return (CR) to get the message
banner prompt.
c Enter a delineator character to specify the limits of the text banner. In the
example below, the % character is the delineator character.
line Enter a text string for your text banner message ending the message with
your delineator.
In the example below, the delineator is a percent character (%).
Ranges:
• maximum of 50 lines
• up to 255 characters per line