Reference Guide

700 | IPv4 Routing
www.dell.com | support.dell.com
Related
Commands
ip name-server
c e s
Enter up to 6 IPv4 addresses of name servers. The order you enter the addresses
determines the order of their use.
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the
no ip name-server ip-address command.
Parameters
Defaults
No name servers are configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out
all other interfaces, including the Management port.
You can separately configure both IPv4 and IPv6 domain name servers.
Related
Commands
ip proxy-arp
mtu Set the link MTU for an Ethernet interface.
ipv4-address
Enter the IPv4 address, in dotted decimal format, of the name server to be used.
ipv4-address2...
ipv4-address6
(OPTIONAL) Enter up five more IPv4 addresses, in dotted decimal format, of
name servers to be used.
Separate the addresses with a space.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
ipv6 name-server Configure an IPv6 name server.