Reference Guide

IPv4 Routing | 701
c e s
Enable Proxy ARP on an interface.
Syntax
ip proxy-arp
To disable Proxy ARP, enter no ip proxy-arp.
Defaults
Enabled.
Command Modes
INTERFACE
Command
History
Related
Commands
ip redirects
e
Enable the interface to send ICMP redirect messages.
Syntax
ip redirects
To return to default, enter no ip redirects.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Usage
Information
This command is available for physical interfaces and port-channel interfaces on the
E-Series.
ip route
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
show ip interface Displays the interface routing status and configuration.
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 6.1.1.0 Introduced for E-Series
Note: This command is not supported on default VLAN (default vlan-id command).