Reference Guide

706 | IPv4 Routing
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
Command
History
Usage
Information
By default, FTOS distributes incoming traffic based on a hash algorithm using the
following criteria:
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
Related
Commands
load-balance (E-Series)
e
By default, for E-Series chassis, FTOS uses an IP 5-tuple to distribute IP traffic over
members of a Port Channel as well as equal cost paths. To designate another method
to balance traffic over Port Channel members, use the
load-balance command.
Syntax
load-balance [ip-selection 3-tuple | ip-selection packet-based] [mac]
To return to the default setting (IP 5-tuple), use one of the following commands:
•
no load-balance ip-selection 3-tuple
• no load-balance ip-selection packet-based
• no load-balance mac
Version 8.3.19.0 Added ingress-port parameter for S4820T
Version 8.3.19.0 Introduced on S4820T
Version 8.3.10.0 Added ingress-port parameter for S4810
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Introduced on C-Series
hash-algorithm ecmp