Reference Guide

708 | IPv4 Routing
www.dell.com | support.dell.com
Related
Commands
management route
c e
Configure a static route that points to the Management interface or a forwarding
router.
Syntax
management route {ipv4-address | ipv6-address}/mask {forwarding-router-address |
managementethernet}
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the
static route (or a protocol route) is preferred over the Management Static route. Also,
Management static routes and the Management Connected prefix are not reflected in
the hardware routing tables. Separate routing tables are maintained for IPv4 and IPv6
management routes. This command manages both tables.
ip-selection 3-tuple and mac MAC based IP 3-tuple MAC based
ip-selection packet-based
Packet based: IPV4
No distribution: IPV6
Packet based: IPV4 MAC based
ip-selection packet-based and mac
MAC based Packet based: IPV4 MAC based
Table 24-3. Configurations of the load-balance Command
Configuration Switched IP Traffic
Routed IP Traffic
(IPV4 Only)
Switched Non-IP
Traffic
ip address Change the algorithm used to distribute traffic on an E-Series chassis.
{ipv4-address | ipv6-address}/mask Enter an IPv4 address (A.B.C.D) or IPv6 address
(X:X:X:X::X), followed by the prefix-length for the IP
address of the management interface.
forwarding-router-address
Enter an IPv4 or IPv6 address of a forwarding router.
managementethernet Enter the keyword managementethernet for the
Management interface on the Primary RPM.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.1.0 Added support for IPv6 management routes.
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series