Reference Guide

IPv4 Routing | 713
Related
Commands
show ip cam linecard
c e
View CAM entries for a port pipe on a line card.
Syntax
show ip cam linecard number port-set pipe-number [ip-address mask [longer-prefixes] |
index index-number | summary | vrf vrf instance]
Parameters
Table 24-6. show hosts Command Example Fields
Field Description
Default domain... Displays the domain name (if configured).
Name/address lookup... States if DNS is enabled on the system.
If DNS is enabled, the Name/Address lookup is domain service.
If DNS is not enabled, the Name/Address lookup is static mapping.
Name servers are... Lists the name servers, if configured.
Host Displays the host name assigned to the IP address.
Flags Classifies the entry as one of the following:
• perm - the entry was manually configured and will not time out
• temp - the entry was learned and will time out after 72 hours of
inactivity.
Also included in the flag is an indication of the validity of the route:
• ok - the entry is valid.
• ex - the entry expired.
• ?? - the entry is suspect.
TTL Displays the amount of time until the entry ages out of the cache. For
dynamically learnt entries only.
Type Displays IP as the type of entry.
Address Displays the IP address(es) assigned to the host.
traceroute View DNS resolution
ip host Configure a host.
number Enter the number of the line card.
Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600600i, and 0 to 5 on a E300.
pipe-number Enter the number of the line card’s port-pipe.
Range: 0 to 1
ip-address mask
[
longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for
that route only.
Enter the keyword
longer-prefixes to view routes with a common prefix.
index
index-number
(OPTIONAL) Enter the keyword
index followed by the CAM index number.
Range: depends on CAM size