Reference Guide

IPv4 Routing | 725
c e
Display the IPv6 static routes configured for the management interface.
Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
Command Modes
EXEC Privilege
Command
History
Example
FTOS#show ipv6 management-route
IPv6 Destination Gateway State
---------------- ------- -----
2001:34::0/64 ManagementEthernet 0/0 Connected
2001:68::0/64 2001:34::16 Active
FTOS#
show ip protocols
c e s
View information on all routing protocols enabled and active on the switch.
Syntax
show ip protocols
Command Modes
EXEC
EXEC Privilege
Command
History
all
Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected
Enter the keyword connected to view only routes directly connected to
the Management interface.
summary
Enter the keyword summary to view a table listing the number of active
and non-active routes and their sources.
static
Enter the keyword static to view non-active routes also.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.1.0 Introduced on C- and E-Series
Version 8.3.7.0 Introduced on S4810
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Regular evaluation optimization enabled/disabled added to display output
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series