Reference Guide

Control and Monitoring | 73
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
Enables periodic audits of software and hardware copies of the IPv4 and IPv6
forwarding table.
clear alarms
c e s
Clear alarms on the system.
Syntax
clear alarms
Command Modes
EXEC Privilege
Command
History
Usage
Information
This command clear alarms that are no longer active. If an alarm situation is still
active, it is n in the system output.
clear command history
c e s
Clear the command history log.
Syntax
clear command history
Command Modes
EXEC Privilege
all
Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib
Enter the keyword ipv4-fib to designate the CAM audit on the
IPv4 forwarding entries.
ipv6-fib
Enter the keyword ipv6-fib to designate the CAM audit on the
IPv6 forwarding entries.
interval time-in-minutes Enter the keyword interval followed by the frequency in minutes
of the CAM audit.
Range: 5 to 1440 minutes (24 hours)
Default: 60 minutes
Version 8.3.19.0 Introduced on S4820T
Version 8.3.10.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command