Reference Guide

734 | IPv4 Routing
www.dell.com | support.dell.com
31 UDP any 162 Q7 6 No - CP
32 UDP 162 any Q7 6 No - CP
33 PIM-SM any any Q6 0 No - RP2
34 IGMP any any Q7 6 No - RP2
35 OSPF any any Q7 6 No - RP1
36 RSVP any any Q7 6 No - RP1
FTOS#
Usage
Information
The IPPTT table is used for looking up forwarding information for IP control traffic
destined to the router. For the listed control traffic types, IPPTT contains the
information for the following:
• Which CPU to send the traffic (CP, RP1, or RP2)
• What QoS parameters to set
Related
Commands
show tcp statistics
c e s
View information on TCP traffic through the switch.
Syntax
show tcp statistics {all | cp | rp1 | rp2}
Parameters
Command Modes
EXEC Privilege
Command
History
Example
FTOS#show tcp stat cp
Control Processor TCP:
Rcvd: 10585 Total, 0 no port
0 checksum error, 0 bad offset, 0 too short
329 packets (1263 bytes) in sequence
17 dup packets (6 bytes)
0 partially dup packets (0 bytes)
7 out-of-order packets (0 bytes)
0 packets ( 0 bytes) with data after window
0 packets after close
0 window probe packets, 41 window update packets
41 dup ack packets, 0 ack packets with unsend data
show ip cam stack-unit Display the CAM table
all
Enter the keyword all to view all TCP information.
cp Enter the keyword cp to view only TCP information from the Control Processor.
rp1
Enter the keyword rp1 to view only TCP statistics from Route Processor 1.
rp2
Enter the keyword rp2 to view only TCP statistics from Route Processor 2.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 6.4.1.0 Introduced